Change a Propane Tank
Forklifts powered by propane are common in warehouse settings. These forklifts have a propane mount located at the back of the operator. These tanks have to be replaced every so often because they have limited lifespans. Forklift drivers must always utilize care when handling propane tanks. Compressed gases are hazardous, especially because the gas is flammable. Always utilize caution when replacing and removing propane tank to prevent being injured.
1 To change a propane tank, first stop the forklift and leave the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns the gas off in the transfer hose which connects the engine and the tank. Prior to taking the second steps, wear the correct safety equipment, like insulated gloves made of either leather or neoprene. It is vital for you to protect your skin from contact with the compressed gas, that is very cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When you put in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 You can inspect for leaks by applying soapy water to the valve and slightly opening it. Leaking gas would cause bubbles to foam around the value. If this happens, check the valve area and the connection hose at the nut. The connecting nut should be re-tightened if you detect any leaks around the area of the valve, and then perform the leak inspection process again. Persistent leaks mean that the connecting hose and nut must be replaced. Nevertheless, if replacing the nut and hose still does not stop the leak, the tank must be replaced.
4 Finally, open the valve all the way to enable the gas to fill the connecting hose. After that you could start the lift truck and resume working.